Schiit Magni 3


3.generasjon Magni hodetelefonforsterker er et kompakt villbeist. Sammenlikne den med hva som helst, du finner ingenting i prisklassen som kan måle seg.

Vår absolutt bestselgende hodetelefonforsterker!

Tomt på lager!

Tomt på lager



This is no “starter amp.” Magni has the power, performance, resolution, and versatility to meet all your needs—no matter the headphone.
Ready For Any Headphone
Magni 3 is ready for any headphone, from IEMs to hard-to-drive planar designs. With a full 2000mW into 32 ohms—rated in the most honest way, RMS continuous, both channels driven—Magni has tremendous reserves of power. Combined with low distortion, an exceptionally low noise floor, and switchable gain, Magni is ready for any headphone.
Powered Monitors Welcome, Too
Magni 3 includes preamp outputs. This means you can connect it to your desktop powered monitors for a complete system—or even connect it to a speaker power amp and use it as a preamp. With its built-in time-delayed start-up and instant shut-down, there’ll be no glitches or pops through either headphones or speakers, either.
Forget $99—Compare at Many Times the Price
Most headphone amps in Magni’s price range use op-amps (integrated chips) for gain and power output. Not Magni. Magni’s gain stage is an-all-new, fully discrete, high-speed, dc-coupled, current-feedback design, completely different than the first and second-generation Magnis. This current-feedback gain stage is typically only found in very exotic designs that sell for more than 10x the Magni’s price.


Frequency Response: 20Hz-20Khz, -0.1db, 2Hz-900KHz, -3dB

Maximum Power, 16 ohms: 3W RMS per channel
Maximum Power, 32 ohms: 2W RMS per channel
Maximum Power, 50 ohms: 1.3W RMS per channel
Maximum Power, 300 ohms: 430mW RMS per channel
Maximum Power, 600 ohms: 230mW RMS per channel

THD: Less than 0.001%, 20Hz-20KHz, at 1V RMS, less than 0.02% at 5V RMS into 32 ohms
IMD: Less than 0.001%, CCIF

SNR: Greater than 108db, unweighted, referenced to 1V RMS

Crosstalk: -70dB, 20 Hz-20KHz

Output Impedance: Less than 0.3 ohms at either gain

Gain: 2 (6db) or 7 (17db), selectable via rear switch
Topology: fully discrete, fully complementary all-bipolar, symmetrical current-feedback design with no capacitors in the signal path and DC servo
Protection: Standard failsafe DC power input and muting relay

Power Supply: “Wall wart” style 24VA 14VAC transformer, regulated +/- 17V rails with over 6,000uF filter capacitance
Power Consumption: 6W

Size: 5 x 3.5 x 1.25”

Weight: 1 lb