Violectric V200


Violectric hodetelefonforsterkene er håndlaget i Tyskland og har en beundringsverdig byggekvalitet.

Utolig flott match til bl.a Sennheiser HD600/HD650/HD700/HD8007HD800s.

Varenummer: I/A Kategori:


The Violectric V200 was developed with the target to enable ultimate transmission quality for low- medium- and high-impedance headphones. Due to its specific, variable, low-noise and low-distortion circuit design especially optimised for dynamic headphones, the V200 fulfils even most sophisticated demands.

LOW-NOISE because of low internal gain. Therefore the self generated noise from the amplifer is not audible.

HIGH OUTPUT VOLTAGE through 60 Volt internal operating voltage. Therefore best suited for high impedance headphones. Over 90 % of all headphone amplifiers in the market offer not half that voltage !!

HIGH OUTPUT POWER because of powerful amplifiers able to deliver much more current a headphone needs. Therefore best suited for low impedance headphones and even magnetostatic cans !!

HIGH DAMPING FACTOR through lowest output impedance. Therefore best suited for full control even over critical headphones with the garantee to have flatest possible


– Balanced inputs with gold-plated Neutrik XLR connectors
– Unbalanced inputs with gold-plated ALPS cinch connectors
– Switchable unbalanced outputs with cinch connectors
– Optional USB input 16 Bit / 48 kHz or 24 Bit / 96 kHz
– PRE-GAIN = switchable input gain in five steps
– Independent-channel design
– DC-coupled (switchable)
– ALPS RK27 High-Grade volume control
– High-Quality op-amps in the signal path
– High-quality MKP capacitors in the signal path
– 0.1 and 1% metal film resistors throughout the unit
– Discrete-design power amp with 8 transistors per channel
– 2 silver-plated Neutrik headphone outputs
– Relay-based headphone output cutoff
– Toroidal transformer
– Large filtering capacitors in the power supply
– Switchable ground lift
– Rugged aluminium case with Nextel coating
– Solid, laser-engraved aluminium front panel